Automation Set for Sectional Doors GfA Elektromaten with Accessories

Set for automating industrial sectional doors, contains: GfA Elektromaten drive SE9.24-25.40 SK DES, GfA Elektromaten door control unit TS970 with CEE plug, 5m motor cable, torque-support bracket, Orion key switch APB 1-2T, emergency stop switch, FRABA VITECTOR optical sensing edge set transmitter + receiver, IP65 eletrical box with status LED for OSE, coil cord 5x0,25mm², relfective photo eye with 7m range

Description:

The automation set for industrial sectional doors (i.e. factories, warehouses, logistics centres, etc.) contains all the components needed to automate the opening and closing of doors. The collection of components is made up of items from renowned brands such as GfA Elektromaten, FRABA VITECTOR, Orion, etc. For detailed information on all the components, such as data sheets, instructions for use, etc. click on the components tab above this product description.
The set contains:
The GfA Elektromaten TS970 door control unit with a 0.7m pluggable mains cable CEE 3N~400V (5 pol.)
- Automatic control unit for GfA Elektromaten drives with digital limit switch (DES) or mechanical limit switch (NES)
- IP54 protection class
- Integrated push button for UP-STOP-CLOSE commands
- Parameter setting via selector switch with digital display
- Independent, programmable relay contact, e.g. for red-green traffic-lights, ramp release mechanisms
- Operating modes: hold-to-run mode or self-hold/ automatic mode
- Automatic detection of safety edge type (Optical edge FRABA VITECTOR, resistive edge 8k2 or NC-contact type 1k2 with testing)
- Automatic timer-to-close
- Adjustable intermediate open position, e.g. half open, venting position
GfA Elektromaten SE9.24 SK-DES, sectional door drive with an output torque of 90Nm and an output speed of 24 rpm is a drive for counterbalanced sectional doors.
- Normally installed directly on the door shaft
- With digital limit switch DES, no need to reset the parameters following a power failure
- Emergency manual override with rapid hand chain operator
- Max. door weight 4000N
- Supply voltage 3~230V/400V
Accessories include a 5m long connection cable for connecting the drive to the control unit, as well as a torque support for mounting the operator to the door.
The reflective photo eye for contactless safeguarding of the door opening.
- Range up to 9m
- All-voltage version: Supply voltage AC 24...240V, DC 12...220V
- 2m connection cable
- Relay output (changeover relay)
Optical sensing edge for the protection of the door opening in automatic mode
- FRABA VITECTOR OSE type
- Transmitter (10.5m cable) and receiver (0.5m cable) included in the set
- For direct connection to the GfA TS970 door control unit
Accessories for connecting the optical safety edge from the door leaf to the control unit.
- Junction box with diagnostics board to display the operating mode of the safety edge
- Spiral cable 5x0.25 mm² with a max. extension length of 3,5m
- An emergency stop switch for surface mounting
One key-switch with 2x impulse outputs OPEN-CLOSE to open the door from the outside